Modifying Urien the Lady Anne

SillyBilly · Post by **SillyBilly** » Sat May 09, 2009 8:38 pm

laalratty wrote:and Taliesin is up next

Even if Uncle Keith takes it off you for dropping it?

laalratty · Post by **laalratty** » Sat May 09, 2009 8:43 pm

I have spoken to him since the incident you know! And if he had taken it off me the tears would of caused a major flood problem in Morecambe (and of course that would of meant that it wouldn't be visiting the Seibiant Hill railway in August

)

SillyBilly · Post by **SillyBilly** » Sat May 09, 2009 9:58 pm

Please note Uncle Keith that at the SHR we have taken precautions to ensure the high level line is not the result of any incident.

laalratty · Post by **laalratty** » Sat May 09, 2009 10:10 pm

SillyBilly wrote:Please note Uncle Keith that at the SHR we have taken precautions to ensure the high level line is not the result of any incident.

And I'll be walking along side it to make sure!!!

bungle80a · Post by **bungle80a** » Sun May 10, 2009 12:53 am

the message that was here made noi sense, so i deleted it!

MoelygestLR · Post by **MoelygestLR** » Sun May 10, 2009 2:20 pm

this incident is a very good reason to have handrails on your (high) bridges. i have two moderatly high (for 16mm scale that is) bridges that both run over a stream. thankfully nothing has gone swimig yet, but there have been close calls and this has made me think maybe its about time i made some handrails!

LMS-Jools · Post by **LMS-Jools** » Sun May 10, 2009 8:24 pm

"Urien" looks wonderful in the flesh, well done that man !

ptlrcecil · Post by **ptlrcecil** » Mon May 11, 2009 1:34 pm

We have always considered adding the half height parapet walls to jubilee bridge but
1. We havent got round to it yet
2. W reckon it would spoil the photos.

By the way ratty your urinal looks brilliant.

bungle80a · Post by **bungle80a** » Mon May 11, 2009 6:38 pm

Got to say ratty, she looks the mutts nuts! I look forward to seeing her at a steam up real soon!

Sammmm · Post by **Sammmm** » Sun Jun 07, 2009 12:08 pm

lol quick question ...... how thick is it black edging

laalratty · Post by **laalratty** » Sun Jun 07, 2009 8:45 pm

It does actually vary to an extent to aviod some of the rivet detailing. It's between 3 and 5mm wide, though mostly 3.5mm or 4.5 mm.

Sammmm · Post by **Sammmm** » Mon Jun 08, 2009 8:28 pm

ahhh thank you very much

Garden Railway Forum

Modifying Urien the Lady Anne

Who is online