Hartland Mack loco conversions

[gregh]

I hope many of you know of the Hartland Mack loco series. These cheap little locos had a great motor block for scratchbuilding or for just bashing the body into something else. Unfortunately I believe they are no longer available.
I had previously used these motor blocks to produce 3 different locos, shown here with an unchanged Mack.

composite mack locos sml.jpg (361.38 KiB) Viewed 550 times

Years ago I inherited one from a mate who had turned it into a Ute by adding a tray to the back.
He had added a battery and a simple forward/off/reverse switch. I did not use it much.

Recently another mate died and before-hand he returned some remote control stuff I had built for him years ago. So as a ‘memorial’ to both these mates,’memories I put Geof’s RC and sound into Bryan’s Ute. It will mainly run on my indoor line, so I purposely made the sound quite soft.
The RC is my usual model aircraft 2.4GHz stuff with a picaxe speed controller and sound. The electronics went in the ute’s tray and I covered it with various loads, mainly made from balsa. The small LiPo battery is underneath behind the motor block as is the speaker.

charge details.jpg (273.56 KiB) Viewed 550 times

finished (2).jpg (401.6 KiB) Viewed 550 times

and a low resolution video on my inside line.

[ge_rik]

A great looking little loco, Greg, and a fine tribute to Bryan and Geof. Sounds good, too!

Rik

[Peter Butler]

That's a great little loco Greg, looks good and handles the curves and inclines so well.