Torrasay Tribulations

Discussion of Live Steam locomotives should be located here
Lner fan Sam

Post by Lner fan Sam » Thu Feb 28, 2013 7:55 am

I might have seen you a few times then matt riding around on the railway.

LlanpwllBrynwyn

Post by LlanpwllBrynwyn » Thu Feb 28, 2013 9:41 pm

I don't know if this will help but here goes...  

I had a similar problem with my Ragleth, in the end it turned out to be the gas jet/burner where it enters into the boiler.  It had become dislodged and did not have an air tight seal.  This meant that the holes where the air IS supposed to get sucked in, to mix with the gas properly, were effectively blocked off due to backdraft.  This in turn caused the flame to not get enough air-to-gas mix.  Some adjustment of the pipes and the position of the burner made it sit in place properly and on testing had a roaring flame...

I realise it is an Accucraft and not a Roundhouse, but I understand they both share a similar closed flue system.

Hope this helps!

TTHLRMatt
Fireman
Fireman
Posts: 321
Joined: Wed Oct 26, 2011 10:20 am
Location: South Shields

Post by TTHLRMatt » Thu Feb 28, 2013 10:01 pm

Yes, very valid point, we put it down to the gunge in the gas tank, when it was silver soldered, it leaves a gunge and when it was posted, was packed upside down so our theory is that this blocked the valve. When we blew it out a lot of gunk did come out as well.

LlanpwllBrynwyn

Post by LlanpwllBrynwyn » Thu Feb 28, 2013 10:03 pm

Hope it all works ok now when its put back together! It really is a beautiful locomotive...

MDLR

Post by MDLR » Sat Mar 09, 2013 9:19 pm

I can vouch for the fact that it worked very well today at Narrow Gauge North!

Lner fan Sam

Post by Lner fan Sam » Sat Mar 09, 2013 9:25 pm

apart from when it ran over the killer bunny(but we wont mention that part!) :lol:

MDLR

Post by MDLR » Sat Mar 09, 2013 9:49 pm

Oh yes - it ran over the killer bunny!

TTHLRMatt
Fireman
Fireman
Posts: 321
Joined: Wed Oct 26, 2011 10:20 am
Location: South Shields

Post by TTHLRMatt » Sun Mar 10, 2013 10:47 am

oh, how did that happen, if its the NWAG one, I dont know where it went but...... I did find some grey ish chunks, oily ones on the inside of the frames :twisted:

DolwyddelanLightRail

Post by DolwyddelanLightRail » Sun Mar 10, 2013 4:12 pm

The original NWAG Killer Bunny was found....it had hopped onto the rather excessively speeding and noisy ( :roll: ) American thing

Lner fan Sam

Post by Lner fan Sam » Sun Mar 10, 2013 4:15 pm

I didn't see anything hehe! :lol:

Post Reply

Who is online

Users browsing this forum: No registered users and 34 guests