3D printed motor block
Posted: Thu Apr 13, 2023 1:44 pm
Just finished off my second 3D printed motor block for my GVT Glyn loco. The Bachmann block I used originally was underpowered (seems to be an issue for me with Bachmann blocks), so I 3D printed my own using the ubiquitous MFA Como 918D 30:1 gear motor.
It was no better in terms of hauling capabilities than the Bachmann block. So, to coin a phrase, I "went large!". I adapted the motor block to take an MFA Como 942DLN gear motor with 50:1 reduction. Somewhat of a beast compared to the 918D, but I managed to squeeze it into the capacious body of the GVT Glyn. I would imagine this loco (with sufficient ballast weight) now has the capability to haul almost all the stock on my railway. Overkill, maybe, but I certainly can't complain about its pulling power now.
I think these blocks are probably have somewhat of a niche appeal, but would be happy to upload the files if there is any interest.
Rik
It was no better in terms of hauling capabilities than the Bachmann block. So, to coin a phrase, I "went large!". I adapted the motor block to take an MFA Como 942DLN gear motor with 50:1 reduction. Somewhat of a beast compared to the 918D, but I managed to squeeze it into the capacious body of the GVT Glyn. I would imagine this loco (with sufficient ballast weight) now has the capability to haul almost all the stock on my railway. Overkill, maybe, but I certainly can't complain about its pulling power now.
I think these blocks are probably have somewhat of a niche appeal, but would be happy to upload the files if there is any interest.
Rik