Big Big train upgrade/customising

TheChestnutLine · Post by **TheChestnutLine** » Mon Mar 14, 2011 12:07 pm

Hello

I bought this Big Big train Ruston back in October. Didn't realise how fast it went! So I finally bought a speed controller from Andel Models and it runs right nice! Just cosmetics like drilling the front grill out, cutting out the door, paint! (maybe green or blue), control panel for the switches and potentiometer, and a proper seat for the driver and fill in the gaps in the sides with plasticard where the switches were. Cut the top of the cab off yesterday aswell

METHSSNIFFER · Post by **METHSSNIFFER** » Mon Mar 14, 2011 12:37 pm

Maybe you would like to pm me and I will give you some other ideas what you can do with your Ruston!

TheChestnutLine · Post by **TheChestnutLine** » Fri Mar 18, 2011 10:28 am

Just an update

Finished making the control panel which just needs a drop of glue to hold it in place. Thinking about what to use for a handle for the speed controller as the cabs quite tight to get your hand in. Any ideas?

Jonnyb · Post by **Jonnyb** » Fri Mar 18, 2011 5:09 pm

Do like them, been meaning to get one for a while.

Look forward to the finished article.

nils holdrinet · Post by **nils holdrinet** » Fri Mar 18, 2011 5:18 pm

Looking good! Perhaps you can drill a hole in the knob and run a small brass rod trough it. Sort of like a lever.

TheChestnutLine · Post by **TheChestnutLine** » Mon Mar 28, 2011 9:12 pm

A little bit more work done

Drilled out the front grill. Just need to add some mesh. New speed control lever in the cab as well which makes controlling the loco a lot easier! Bit of copper wire will be added for a handle.
Sorry for the bad lighting.

Sir Clothem Cap · Post by **Sir Clothem Cap** » Tue Mar 29, 2011 9:36 am

I was going to suggest that you could make the speed controller into an exhaust pipe but your lever solution is great.

TheChestnutLine · Post by **TheChestnutLine** » Tue Mar 29, 2011 9:57 am

Sir Clothem Cap:51234 wrote:I was going to suggest that you could make the speed controller into an exhaust pipe but your lever solution is great.

That was an idea I had in mind but the speed controller is not as smooth as I hoped but having a lever means I can nudge it slightly to make fine adjustments

Sir Clothem Cap · Post by **Sir Clothem Cap** » Tue Mar 29, 2011 10:11 am

It's easier to see where its set at too. An excellent solution.

Garden Railway Forum

Big Big train upgrade/customising

Big Big train upgrade/customising

Who is online